Answer Posted / rakesh
HT CABLES ARE HIGH TENSION CABLES AND LT CABLES ARE LOW
TENSION CABLES.
Is This Answer Correct ? | 2 Yes | 6 No |
Post New Answer View All Answers
Sir, plz tell me how droop setting is done in parellel operation od DG set ? please give practical example ?
Pl.brief me about Electrical power distribution system from Main generating station to Industry.What is the use of in between station.
What is a surge supressor why its is used in synchronous generators
Which type of DG need Netral Earthing?
I am using submission of two ct in one and half scheme for 67/67N protection. Both CTs star point is grounded separately near ct box.Will two point ground give wrong tripping to 67/67N during fault or no matter.
Is it advantages of having star-delta vfd than normal star vfd , if yes why?
I'm looking for a mnaual set for a Teradyne J750. Softcopy would be preferred but I'll take what I can get.
In an ACB shunt trip coil and undervoltage coil operated normally( breaker open and charged). But closing coil not operating untill manually discharge and recharging. Any help.
I want to calculate how much capacitor we connect to maintain the unity power factor? Is there any formula? Pls give me the answer
What is milivolt dop test in Busducts? What is its significance & procedure to do the test?
how we design a pannel to start 10HP motor with the help of star delta starter?
HOW CAN WE DECIDE THE SUPPLY VOLTAGE FOR MOTOR ACCORDING TO ITS RATING(IF ANYONE KNOWS GIVE IT WITH EXAMPLE AND ITS CALCULATIONS)
i karmveer bharti persuing b.tech . plz send me syllabus and name of reference books. for preparation of section eng.
WHat is the general checks required for Dry type transformers
Can anybody just suggest about the scope of Electrical design with ETAP software?Just guide me?