why surge suppressor in vaccum circuit breaker and it is
only in motor feeder why not in tranformer feeder?no surge
suppresor in ocb in motor feeder?
Answer Posted / kalyan dilip
Surge Suppressor is used to control the current
fluctuations.In motor there will be fluctuations in current
with the change in load. So Surge Suppressor is used in motor.
In case of Transformer there will no fluctuations in current
with the change in load because voltage is maintained constant
therefore it is not neccessary to use Surge Suppressor in
Transformer Feeder.
send your feedback or your doubts to kalyan.dilip0@gmail.com
Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
what is the acceptable value of TAN DELTA and dissipation factor for 11kV, 1.75HP Motor?.
Graphs of measuring power and speed on dc motor
WHAT IS THE TOTAL POWER GENERATION IN CHHATTISGARH?
can i use ups power as a raw power for another ups
what would happen if reactive power (kvar)is increased (more)or decreased (less)? how much exact reactive power should be maintained? and what should be done for that
What will be electrical cost per sqft for IT building (basebuild and fitout)and for residential township?
what is the minimum pay scale for electrical engineer (building construction)in kuwait? plz revert back with yrs of experience & pay scale respectively.
what is meant by tranformer impedance?
what type of earthing do for dry fissure rock?
What is the rating factor for copper cable ( Specific value according to the type of laying ) & the voltage drop?
Tell me in detail about c.t. And p.t. ?
If we are given a 10 amp cable type and asked to calculate the number of cores used and the thickness of the cable, how do we do it?? please help...urgent!! i hope the question is clear enough!!
What will be the current drawn by HT motor, if low voltage is applied.. any formula to calculate the LT amps of HT motor.?
in dc series motor if field wdg is shorted then
we are going to install a solar PV site and how can we calculate PV Solar Panel Efficiency, can anybody tell me complete method for its calculation.