Interested to Buy Any Domain ? << Click Here >> for more details...
what is brushless generator.How does work it..??
- 3 Answers
- 9051 Views
- NTPC, I also Faced
- E-Mail Answers
Answer Posted / sakthivel perambalur
we know that dynamically induced emf and statically induced emf
| Is This Answer Correct ? | 4 Yes | 5 No |
Post New Answer View All Answers
What are the main advantages of generalized error co-efficients?
How can we calculate the transformer rating if the load calculated is 1000KW (11Kv Supply)?
Why do we avoid electrical conduits in floors at apartments?
If oil and air can withstand a high MeV when used as an insulator in a transformer, what are the values of how high for each material?
Is it possible to obtain 480v or 550v in single phase output by giving the input to 230v to a single phase torodial type transformer without using a stepup transformer?
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
What will be electrical cost per sqft for IT building (basebuild and fitout)and for residential township?
Formulae for calculating the transmission line losses for different voltage levels
How to calculate wire length,size & current? ( related to control panel)
which phase is preferred for connecting 1 phase vt used for synchronizing OHL? WHY?
A 7 storey building has a floor area of 35,000sq.ft on each storey. On the ground floor 11KV electrical sub-station is to be erected. A load of 3kw for every 400sq.ft (p.f is 0.8) is proposed for each floor. fire pump 7.5hp, water pump 5hp, lift 2 nos, each 10hp and 20shop load of each shop is 5kw. calculate a. load each floor b. total load of building c. L.T feeders for aech floor and from transformer to main. d. distribution diagram e. capacity of sub-station/capacitor bank f. line diagram
What is the basis for selecting Vk/2 or Vk/4 for REF and Differential protection of Transformer and What is the significance of magnetising current
how does grading rings & spacers in transmission line works? Working Principle?
How each of the following losses occur in d.c machines (i) copper (2)core (3) windage (4)friction please help me
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
