Interested to Buy Any Domain ? << Click Here >> for more details...
what is full form of SMART
- 46 Answers
- 92286 Views
- Infosys, ITC Infotech, Lanco, Rosemount, Solvay, I also Faced
- E-Mail Answers
Answer Posted / ankit narang
Specific, Measurable, Achievable, Realistic,Timeout
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How does temperature bath work? How does coil gets heated only by applying some current?
Q- Control problem are mainly classified in _____ types. a-)4 b-)3 c-)6 d-)nono of these Few of them i know is 1- regulator type problem (eg- Air conditioner) 2- tracking problem (eg missile trcking problem) 3- sybernatics 4- optimal control problem
why direct mounted pressure transmitters is always installed with DBB ( double bleed block) valve in process line or top of the tanks ?
Draw a group of instruments interlocked to a Pump & Motor?
State bernoulli’s application.
How d.p. Transmitter can be applied to open tank?
what does it mean an active front end in vfd plz explain it briefly
What is the advantage of using locally fabricated hook ups over Pre fabricated hook ups in process instrumentation?
what is piezoelectric transducer?give an example in power plant n state its principle?
what is use of communication wire in multipare cable(oil and gas field), why this communication wire not used in single pair cable?
what is performance test.need defination
what is the responsibility of an instrument commissioning supervisor
Explain about safety integrated level protection? . How it was differ from other protections ?
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
the 3 most common transmitter protocol being in refinery or qatar gas and aramco.
