Interested to Buy Any Domain ? << Click Here >> for more details...
How to calculate the Meter constant for the given Meter (by
using any formula)
- 4 Answers
- 78223 Views
- HCL, Viva, I also Faced
- E-Mail Answers
Answer Posted / sai kiran
I want to know all about the circuit diagram for energy
meter. So please send to my mail.
| Is This Answer Correct ? | 14 Yes | 11 No |
Post New Answer View All Answers
some basic standard questions on transformer.
why we use single core 630mm2 cable for transformer secondary side
why we permissive overreach in distance protection.where it is applicable to use in long r short lines
How to calculate KVA/VA rating of PT or CT from primary & secondary voltage or primary & secondary current?
if 12v battery get discharged for 2 months after if we put charge it will charge again?how much time it will take to charge?
how we start 40w tube light with 4 diodes,2capacitors,1 choke and without starter.(a product avilable in market which lights burnt tube lights also)
if in 3-phase system voltage=440V,frequency=60Hz, current=400A. then if it is single phase then current=? and if it is single phasing then current=?
How can I calculate the Mega watts required to run a plant having many electric motors and other electrical components.
is it value of power factor is more than unit. whats effects in the source supply
What is ideal IR values for ground and neutral.
How do I calculate a WTI CT ofa 1250kVA 6600/400V transformer
What is the comparison of PILC and XLPE cable
Control cables in S's will carry 1000v which is AC R DC? Pls answer me
what is vA rating and class of a ct.
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
