why delta delta connection generally not use in transformer
Answer Posted / suhail a.
Because generally in transformers we need to get a neutral
point form the star that is what we r not using the delta to
delta.
Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
what is the transmission loss for electrical supply? specifically a large shopping complex where the grid is half KM away, what will the % of transmission loss? is there any transmission loss for captive unit generation for above set? thanks
when qty of cable being purchased is not sufficient according to the standard,what should the inspector do to ensure its quality according to the standard?
As we know induction squirrel cage motor torque Directly praprortinal to applied voltage in star connection & delta also. If I connect 55KW Motor to DOL starter in load condition does motor withstand the load & what will be the current withdrawn ? motor will not fail ?
how current is reverse from its normal direction during the fault?
May I know how much values to be set for earth fault, over current and short circuit values at 11kv side? I have 11kv van 1250amps rating. Present it's taking load 80amps?
While converting delta into star or star into delta ,the three values of resistances remains unchanged .Find out the value?Let In star R1=x;r2=x;R3=x On converting into delta,R12=x;R23=x;R31=x Find the value of x
How much current will a 5 HP delta connected motor at no load will take?Is tat need a starter
a 100mva,400/200v transformer has leakage impdce of 10% draws a steady state line currentof---------------
why capacitance effect is predominant in underground cable transmission and inductance effect is predominant in over head line transmission?
HOW TO SELECT THE COPPER CABLE SIZES OF MOTORS,TRANSFORMERS?
Which device of PlC does share load between DG sets when DG are running in perallel?
How is the gain affected by the introduction of feedback in a control system.
What is effect on in zone and out zone fault if CT chosen for phase side is Vk/2<5mA and Neutral side is Vk/2<15mA on REF protection of Transformer
where are the circulat the diesel in DG parts name with pictue
Explain about c.t?