Interested to Buy Any Domain ? << Click Here >> for more details...
we convert 66kv to 33kv then 33kv to 11kv,11kv to 440v.why
not we convert directly from 66kv to440v?
- 7 Answers
- 20365 Views
- HCL, L&T, I also Faced
- E-Mail Answers
Answer Posted / jaheerabbas
if we are converting the 33Kv to 440v directly, wastage of
power is more in the form of heat,so that we required large
no of heat sink too....heat sink cost will be more compare
to transformer, so that we go for the step by step convertion
| Is This Answer Correct ? | 14 Yes | 10 No |
Post New Answer View All Answers
what are factors to be consider to design a HT & LT motor?
Explain about 3 phase motor fault current calculation with examples?
How grounding is different than earthings?
How to decide no. of Step and Kvar for APFC Panel 40 kvar MD: 33.12 KVA Avg pf : 0.8540
I need a formula to calculate the size of cable as per load but in the terms of length. Please Reply me as i search lot of sites but i did not get the answer.
what is the effect of un-synchronized power.
What kind of socket shall be provided for window type air conditioner with cooling capacity upto 18000 BTU/hr
1.what is the funtion of chiller primary & scondary pumps. 2.what is the use of distribution lines & Types. 3.what is the use the thermal power stations & how much capacity.
The electrical energy required to raise the tempreture of a given amount water is 200 kwh. If the heat losses are 20%, the energy required is?
What happen when neutral point connected to core balance current transformer? (Neutral point of an alternator of a 180KVA DG. Neutral point connected to CBCT means enter to the CBCT)
WHAT IS DEGREE OF COMPOUNDING IN D.C MACHINE MEANS? HOW TO READ THE OPERATING CHART FOR ANY ELECTRICAL MACHINES?
What are the parts in a inverter?
how to get electrical supervisour certificate in gujarat
How good are you in resolving the commercial issues to Employer's advantage?
Can we test the alignment of End shield and stator of turbogenerator without rotor insertion? Also how to fix maintain the alignment at site installation?
