Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between star and delta connection ?
when we use each one ?what is the best ?
- 14 Answers
- 55723 Views
- Amara Raja, Daikin, I also Faced
- E-Mail Answers
Answer Posted / ramesh
Star Connection:
1. It is a setup where in one end of each phase is
connected together so as to form a neutral.
2. It is used for variable loadings
3. The line current = Phase current
4. The Line voltage = sqrt(3)* Phase volatge.
DELTA CONNECTION:
1. It is a setup where in one end of one phase is joined to
starting end of another end so a ring is completed.
2. It is used for balanced loads.
3. There is no neutral in here
4. Line current = sqrt(3)*phase current
5. Line voltage = phase voltage.
line volt- voltage taken from two live wire= voltage taken
from one live neural connection
| Is This Answer Correct ? | 27 Yes | 6 No |
Post New Answer View All Answers
what happens in the short circuited secondary transformer,if the resistance of the short circuit is increased gradually?
how to calculate the Neutral transformer impedance?
How will A Medium voltage circuit breaker(11 kV voltage level) operate under short circuit fault condition whether It is having short circuit release like Low voltage circuit breaker or relay should be given?
what are the preventive maintanance actions taken for air circuit breaker? please answer me
How can calculate the rating of a alternator for a given specific load with formula
what is the diff. between x'mer , isolation x'mer & ultra-isolation x'mer ?????????????
Whats the difference btwn a latch, port,data bus buffer? Do they all not hold data in d flip flops??
what are the assumptions made in swineburne's test?
If only R Phase is connected in 2 pole elcb, n is not connected than it will work or not in ground fault.
What is the drawback of class b amplifier?
What is the comparison between 30mA DP RCCB and 100mA DP RCCB and can replace it against 63A MCB
HOW WE CAN REDUCE THE CIRCUIT COMPLEX OF STAR-DELTA STARTER .BECAUSE NOW WE USING ONE TIMER RELAY & THREE CONTACTOR FOR MAIN,STAR & DELTA ?IF ANY IDEAS PLZ POST.THANK U
how to test and calculat the head and discharge in borewell compressor
what can be the causes of capacitor start motor having a higher current that its actual
If ROC does not lies inside unit circle,then ? a) Fourier transform converges b) Z transform converges c) Hatly transform converges d) Colpit Transform converges.
