Interested to Buy Any Domain ? << Click Here >> for more details...
How to calculate the size of the cable? for exp i want to
use the load of 10HP
- 4 Answers
- 7219 Views
- I also Faced
- E-Mail Answers
Answer Posted / anil
Sir, it is simple 10kw motor will take 14 amp current in
normal running of motor but at starting shall take about 5-7
times more in case of induction motor. so we will consider
the cable accordingly
| Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
I want single line diagram for AMF & DG syncronizing panel
What is method of calculating the fault current for a MDB, 50KW, 3PH, 415V, 50HZ?
why magnet has north and south poles only why not east and west and why we are considering as north and south poles? why cant we consider as east and west?
What size cable (based on voltage drop) is required to supply a 40 A three phase boiler if the wiring system is 75V single insulated cables installed in non-metallic rigid conduit 56m from the main switchboard? Voltage drop in the consumer's mains is 8V.
hello! sir i did three year of diploma in electrical (2007- 2010) and now i m a student of electrical engineering. sir can i apply for germany visa for study and part tome work over there?
How many double suspension hardware fittings are required on a double circuit transmission tower?
Can we check ELCB constantly from R1 to R8 phase in 1 no DB?
Is vtg is controlled by the resistor? if else how much?
What is electrical diversity factor in electrical installations?
There are Two questions about Steam Turbine Generator... What is HRSG bypass of LP, HP used for in power generation? In particualar, in the event that fault of HP bypass, there would be STG TRIP in operation but none on the LP bypass fault...what's the reason ?
what is the grounding Calculation formula? spouse i want to provide grounding to 3phase 18kw motor or i want to provide ground to 3phase 10kva dry type transformere or you give me any exemple...... Thanks.
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
What is mean by hot and cold loop testing?
What is the formuala to calculate the rating of motor protection circuit breaker
What is the basic of DTH.
