Answer Posted / tarun aggarwal ymca
The substations can be classified in several ways including the
following:
i) Classification based on voltage levels e.g.:
AC Substation: EHV, HV, MV, LV; HVDC substation
ii) Classification-outdoor or indoor.
Outdoor substation is under open sky. Indoor substation is
inside a building.
iii) Classification based on configuration, e.g.:
a) Conventional air insulated outdoor substation or
b) SF6 Gas Insulated Substation (GIS)
c) Composite substations having combination of the above two.
iv) Classification based on application.
a) Distribution substation
b) Switchyard in Generating Station
c) Switching substation (without power transformers)
d) Sending-end substation
e) Receiving substation
f) Factory substation
g) Compensating substation e.g. having static var compensation etc.
h) Load substation, e.g. arc-furnace substation.
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What are the causes of having an rmu explode after installation? And how do u treat the bushings of an rmu?
how are reversing the direction of rotation of dc motor
what is the difference between 4pole & 6pole DC Motors & give advantage ?
how commomn gate triggering is given for TRIAC ? other thyristor wont be efffected?
What is the function of under voltage release ?
How can two 3 phase transformers of same KVA and Voltage be connected in parallel?
Dear Respected sir how to test ABB REX521 protection relay by relay tester.
What are the factor to be consider for CT selection in 132kV substation?
i am completed my degree(B.E EEE) 2014 anychance to get electrical licence plz help me
Why does an induction generator is preffered as compared to synchronous generator in especially a wind energy power production project?
what is meant by tranformer impedance?
While performing stability test of differintial cts how to know the voltage and current on both side of the transformer?
On 400 amp factory load how kvarh capacitors provide
How can we increase fuel-power ratio of any DG set?
How can eliminate noise problem inside temperature controller temp. variation due to contactor chattering problem.