Interested to Buy Any Domain ? << Click Here >> for more details...
in dc shunt generator field is open in running condition
what will happen?
- 8 Answers
- 14503 Views
- century, I also Faced
- E-Mail Answers
Answer Posted / j.d
if the field winding of the shunt generator gets open then the generating voltage gets reduced to very low level finally it gets zero output from the generator, because field winding is the main element to produce flux. The flux is directly proportional to the output voltage.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
How To increase Knowledge Of boliler regarding To Only Electrical Field..
how can we phase identification in a distribution line,how we recognise that which phase is coming for a house hold connection.help me............
draw the full wave and half wave circuit of 3 phase system and inverter circuit used in ups
wat is d diffr btw shunt coil and trip coil in VCB?
3Cx240 & 3Cx300 sqmm Al. cable from lv side. What is the calculation for this cable??
the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?
What is slope...? Explain slope 1 and slope 2...?
Is it required to lay 2 runs of GI wires along with armoured cables from one power DB Machines of higher rating?
How to Prepare preventive maintenance shedule of machine tool.
In how we connect watt meter for open & short circuit test of a single phase transformer.
importance of reactive power management
why do motors burn out? I understand why adding parallel loads to a power source means more current moves through the circuit, and can destroy circuit elements by overheating. What about when you have a vaccuum cleaner intake flush against a floor, a room fan sitting directly against a wall, or a power drill trying to drill through something too hard?
draw the restricted earth fault protection circuit install on power transformer and identify its parameters and draw C/C curve of it
Why is water motor not taking the pressure? what is the problem?
what is the IEC standard for Power Cable installation in onshore (like in direct buried ground or above groung)
