Interested to Buy Any Domain ? << Click Here >> for more details...
In 16' pipeline one pcv is installed which is controlled by
PT installed at inlet of PCV.If Flowrate in pipeline
increases what will happen to pressure at the inlet of pcv.
- 5 Answers
- 11111 Views
- Essar, vssc, I also Faced
- E-Mail Answers
Answer Posted / kuber
The pressure will be proportional to the flow rate, as the
flow rate increases the pressure at inlet of the valve will
increase. then the valve starts to close relatively.
| Is This Answer Correct ? | 17 Yes | 3 No |
Post New Answer View All Answers
What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.
How oil line flow measured?eplain about instruments used and working principle?
Why all the drains(Gland sealing,ESV,Casing inlet etc) are directly connected to the flash tank instead of hotwell of the condensor in the power plant? My Email Id:naba02222@gmail.com
How to Calibrate Temperature Switch in field
State bernoulli’s application.
what is cems analyzer explain with principle and drawing ?
what is Best Among SINK Or SOURCE Type Design In Digital Signal, Either Iput Or Output? WHY?Can any one..
How to Calibrate Level Switch in field
how we are selecting instuments by differentiating certain instruments in 4 to 20 ma range and certain in 1 to 5 v dc
sir i m preparing for BARC but i am not getting any papers to prepare for this exam so please send me some sample papers to my i.d for the preparation of barc.
Calibration of controller (pneumatic)
Hi Friends i need Electronics&Instrumentation Engg question papers for BARC written test by coming 20th May 2008 pls post ur use full info to kkumarei@gmail.com. Or for suggestions pls give one missed call to 9962122264
which type of filter gives the constant phase characteristics?
Which type of pressure can be measured by these elements?
What is the procedure of calibration of Load cell?
