How to calculate meter constant @ HT yard
- 5 Answers
- 10149 Views
- Juniper Networks, I also Faced
- E-Mail Answers
Answer Posted / mohamed ali.m
My Dear This Answar.
Metering Constant.
PT Ratio x CT Ratio X Dial Constant/Meter PT Ratio X CT
Ratio
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
DC transmission
what is the major difference between LIBBP & HIBBP.. which one is most preferable..
What is earth system using on the floater TN-S or TT. Iam not sure and what ICCP
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
where reactive power is used
Following test should be conducted to find out relative polarity of transformenr terminals A no load test B back to back test C phasing out test D none of above
why starting current is high and resistance is almost 0 during the starting of motor dc motor...?
1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?
What is the actual calculation for transformer short circuit test?.
What is the function of the circuit breaker failure relay?
why the colour of insultor stack , petticoat is brown. Is it has some technical reason.
For R-L or R-C ckt,time constant formula is L/R and RC respectively and its unit is in sec.Pls tell me the derivation
can anyone tell me can the electromagnetic waves can be reflected back?if so how &by which material it can be reflected back?please tell me so that it can help to my wireless power trasnmission device.
In a flange coupling, the flange bolts are designed for
I have a small system with two motors that are running on 380 vac, 60 hz. These motors are expensive and I usally get them from Brazil. I am adding another motor to the system, but I want to purchase a 480 vac, 60 hz motor to use. It will be on a VFD that is rated fro 380 thru 480. Is this posible and will I have to use a larger motor and derate it?
