WHAT IS BASICS TO SELECTION OF 11 kv Trasformer, send any
calculation sheet for selection of transformer
Answer Posted / shiva
for any application selection depends on local distribution
(sub station ) transmission ,secondary voltage and finally
depends only on demand KVA of u r plant.
Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
how to increase or decrease speed in DC shunt motor by DC convertor
how much GROUND & NEUTRAL VOLT maintain in data center.
If we have use two power cable for incomer, that time how many use cbct for earth leakage protection? 1 or 2 if 1 way? If 2 way?
State the factors, for the choice of electrical system for an aero turbine.
What is meant by reset level of the relay?
Why we use duplex coil and hook switch in telephone system?
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
If 100 KAV USP dedicated earth got disconnect / Cut. What will happen at load.
WHAT IS THE FORMULA FOR CALCULATING CURRENT RATING(DIRECT IN GROUND OR AIR) OF ARMOURED(XLPE) CABLE OF 4C,16Sqmm?
number of I/O devices in siemense plc
in what type of applications v can use q meter?
WHAT IS START TO INDUCTION MOTER IN STAR TO DELTA OF >5HP ?
How many double suspension hardware fittings are required on a double circuit transmission tower?
should %impedance be high or low in a power transformer? if so why?
What is minimum permicible value of leackage current for LT Panle when applying voltage up to 3 KV for 5 Minuits?