What will be the direction of rotation of a Alternator in case
it goes in motoring action when connected with grid ?
Answer Posted / arvind kumar
IT WILL NOT ROTATE,BECAUSE FOR LARGE MACHINE ARMATURE
WINDING IS PLACED on STATOR AND FIELD WINDING ON ROTOR,the
field winding is exited by dc.THE OUT PUT IS DRAWN FROM
STATOR,IN CASE ARMATURE WINDING WHEN CONECTED WITH GRID THEN
DUE TO INVERSE OF FARADAY LAW ELECTROMAGNETIC INDUCTION THE
ARMATURE WINDING WHICH IS PLACED ON STATOR EXPRIENCES TORQUE
under the influence of flux priduced by field winding,but
this is not possible to rotate the stator.for motoring
action is possible in small ac machine in which armature
winding is placed on rotor and field winding on stator
...read p.s bhimra page 239
ph7376722798
Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
how does the terminal voltage of transmission lines increase when a capacitor is connected???? This happens not only in transmission lines but also in all circuits. How??? When a capacitor is connected in a transmission line, capacitor also takes energy from the same supply. But how is it able to increase the terminal voltage??? Practically What sequence of events happen during increase in voltage???
If we want to change a contactor of faulty one what are the conditions want to fullfil
what is tri state logic gate
why should the primary of transformer be connected in delta in a heat run test?
What is the basic of DTH.
what are the specifications we must look at to select a relay for any capacity motor?
WHAT WOULD BE THE FORMULA OF WIRE GAUGE FOR A FULL LOAD CURRENT
how to calculate insulation level of transformer?
What happened ,If 3 phase clearance not maintained in 33KV Line,11KV LIne etc?
HOW DO I CALCULATE THE SETTINGS FOR THE DIFFERENTIAL PROTECTION OF A 12kV/6.6kV, 6MVA,DYN11 XMER WITH PRIMARY SIDE CTR 400/1 AND SEC SIDE CTR 600/1?
Fantio of tranformer
Why we use mho Relay in long transmission line?
why different series of vfds (like allenbradley)are used in industry ?
How would you calculate power loss in a resistor?
Why electrical power generation and transmission done in 3 phase system not more than 3 phase ?