Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between concentrated winding and
Distributed winding in motor?
- 7 Answers
- 50053 Views
- BSL, Infosys, TCS, I also Faced
- E-Mail Answers
Answer Posted / ramya
distributed winding is one in which the windings are
distributed along a number of slots. the major merit of
this is the heat dissipation is better.
whereas in concentrated winding, the windings are
concentrated only on one slot. here, since more number of
coils is in one slot, the heat produced is more.
| Is This Answer Correct ? | 50 Yes | 13 No |
Post New Answer View All Answers
Can anyone tell me some hints about what type of questions are asked by the interviewer by an Electronics engineer when company is installing an IPP and wants a team of engineers?
When semiconductor fuse does save thyristor in each cycle of conduction? Why under voltage setting keep less in SPRS and more in DC drive?
Does the direction of rotation of d.c. Shunt motor would get reversed if the armature current and field current both are reversed?
The loads are connected with phase and ground then why current flow as the loads ?
Draw the single line diagram of the power station?
1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?
what purpose to use excaiter in DG.?
how to calculate the fault in substation
WHERE NEUTRAL WIRE IS CONNECTED AT DOMESTIC TO TRANSMISSION LINE(SINGLE PHASE TO THREE PHASE)
How to calculate capacitor bank value to maintain unity power factor with some suitable example?
what is doubling factor in making current of a breaker?
how to fit 3 HP crompton gear motor with conveyor with the use of staring delta starter or ordinary starter?
Either the Armoured Earthing strip of HT 3 core cable have to pass through CB CT or not , why ???
What are operating procudures & Safety precautions to be observed while operating OLTC in manual mode ?
Can u explain : what is supply for train (whether a,c or d.c ).I know that supply is 25000v a.c .But there is rumour that supply is D.C. And also explain how lights and fans inside the trains are working ,and what type of motors are used in trains whether D.C motors or induction motors .If d.c motor, how it gets supply.If traction motors are used then what are traction motors and its functions and how it differs from other motors and also explain about locomotive . y d.c series motor in train.train wheels r driven by D.C shunt motor ,at what voltage,and at what speed. please reply..............
