Interested to Buy Any Domain ? << Click Here >> for more details...
Why we didn’t feel electric shock in an electric train ??
- 10 Answers
- 30356 Views
- NTPC, I also Faced
- E-Mail Answers
Answer Posted / kaji mustufa
As the source used in trains is from overhead lines and it makes contact with PENTOGRAPH contactor but pentograph contactor is insulated from coaches by mounting insulator discs on the top of train..
summerising, electric train and source (i.e. 25kV dc) is electricaly not connected.. Hence no shock....
| Is This Answer Correct ? | 7 Yes | 2 No |
Post New Answer View All Answers
1.what is the reason for transformer and lightning arrester blast in 33kv system
Damping resistor provided in open delta (tartiary) winding of a measuring PT at the incoming of a MV inverter drive panel is getting heated up. Can any body explain the reasons and suggest the remedy?
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?
in ACB breaker requireding 3200Amps. buscoupler getting OFF mode and again it reset and getting normal position give me a required answer?
In India the supply voltage is 230 volt A.C. During the negative half cycle phase becomes neutral and neutral become phase? or what will happen during negative half cycle? how the electrons flow during positive and negative half cycle?
what's the difference between abs/inc encoders. apart from the position remembrance what are all the other differences. and what's mean by grey code.
how can found motors folt current ? how can disided circuit breakers caoicity and breaking capicity ?
What do you understand by avr?
why power factor is important?
how to determine Sq.mm size of finolex power cables.
What are the main advantages of bode plot?
which type of amplifiers are used in multimete?
ii) A shunt motor supplied at 230V, runs at 900 rpm when the current is 30A. The resistance of the armature is 0.4 ohms. Calculate the resistance required in series with the armature to reduce the speed to 600 rpm, assuming that the armature current is then 20A. [12]
Z transform is use when system is not a) converges b) diverges
Why reactors use before incoming of ac vvfd drive?
