Interested to Buy Any Domain ? << Click Here >> for more details...
why we use only 4 to 20ma other than 0 to 16 ma
- 5 Answers
- 9345 Views
- Invensys, Systech, I also Faced
- E-Mail Answers
Answer Posted / vimal
Whether our instrument is in good condition or not, in order
to check that we are using 4ma as a low value. If we use 0
ma, We can't say that whether the problem is in instrument
or in supply panel.Normally, when we not give supply to the
instrument it will show 0 ma. for that, we use 4 ma as a low
value. Moreover we use 4 to 20 ma as a standard output
because to get linear graph. So, we prefer 4 to 20 ma
instead of 0 to 16 ma..
| Is This Answer Correct ? | 33 Yes | 2 No |
Post New Answer View All Answers
What is ultrasonic flowmeter?
what is exact time to study dcs and plc cources
How flow can be measured with dp?
What is 1:1 redundancy ?
In my company plc based winders are operated. one day there was a data transmission failure alarm shown on pc. as per sir instruction we have reset master plc but winders were not triped and alarm gone. so what master plc do?
why direct mounted pressure transmitters is always installed with DBB ( double bleed block) valve in process line or top of the tanks ?
How a conductivity sensor & analyzer work at boiler, whats the principle & science is beyond this,How conductivity sensor sence & convert signal & move toward analyzer & analyzer show reading in percent? also what is temperature compensate option in conductivity analyzer
How to calibrate radar type level transmitter for interface level? Total liquid(liq.1 and liq.2), level both the liq individually? For. Both the liquid levels how the signal will go from transmitter to dcs? How to calibrate. Single radar 9:26:55 AM for 2 different liquids in a tank?
where proximity sensor installed on tank in loading arm application
What is the start up procedure of desalter
send me model hpcl questions pleas..........my mail id mohideen.dharvesh@gmail.com
How earthing can be checked????
sir, give me placement papers and interview quistion of birla group company of copper.
Define the terms Accuracy, precission, Spam, process tolerance while doing calibration of an instrument? Explaini with an example?
What are different types of orifice plates? State their uses.
