Interested to Buy Any Domain ? << Click Here >> for more details...
why does cycle rim dont bend even in heavy loads???????
- 7 Answers
- 13257 Views
- Nissan, I also Faced
- E-Mail Answers
Answer Posted / ronnie
it is misconception
that spokes are in
compression while
loading.
Spokes being thin are
god in tension than
compression.
If you observe the
spokes they are fixed
at hub bt slightly free
at wheel.
Whn load appld the
lower spokes expnd
in whel whch brings
all spokes in upper
hemisphre in
tension, who actualy
tak load.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
what is the difference between type -a and type -b iron > The chemical compostion is given here under and also guide us the effect of Ni;Cr;Mo in the iron; name and use of these two types of iron Type a Type b %C :3.15 2.65 %Mn:0.41 0.52 %Si:1.72 1.60 %S :0.090 0.082 %P: 0.215 0.204 %Ni: 0.40 Traces %Cr : 0.49 Traces %Mo : Traces Traces
What are four types of turbine seals?
What is the difference between blower and fan?
Define earth lamp?
What is the use of pneumatic system?
Why rate of condensation is higher on a polished surface compared to rusty surface ?
If you have a valve with an applied pressure, how do you determine the stress to the closed and open valve?
L&T construction mechanical questions
After any cause of repaired how i start the engine by slow speed 800 to 900 rpm electronic control moudle engine [cummins]
What is the unit of viscosity?
what r the advantages and disadvantages of gas burners and oil one?
What causes turbocharger surging?
what is the use of vacuum balancing valve in CEP
Which heating value is indicated by a calorimeter and why ?
what is the technology used in sap?
