Interested to Buy Any Domain ? << Click Here >> for more details...
what is the basic working principle of I/P and Positioner in
any control valve.
- 12 Answers
- 80841 Views
- Essar, Visa Steel, I also Faced
- E-Mail Answers
Answer Posted / parag pathak
I/P works on Motion Balance and Positioner works on Force
Balance priciples
| Is This Answer Correct ? | 5 Yes | 20 No |
Post New Answer View All Answers
what is the procedure for auto tune in masoneialn 12300 series displacer type transmitter?
Linear amplifier.
why Fahrenheit unit of moistur analyzer transmitter
Explain the working of rota meter.
Explain about the leakage class of the control valves
what does it mean an active front end in vfd plz explain it briefly
what is isloted barrier how it works and what are the main purpose.how it make safe area.
HOW CREATED LP & HP PRESURES IN DRUM FOR DRUM LEVEL MEASUREMENT!
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
How can test or measure the probe and extension cable to identify if the problem at the probe or cable or at the driver it self? (pleast notify the measuring method)
how many pulses are required by a ac induction servo motor of 4 poles with 50 Hz frequency to rotate by 1 degree?
I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.
any one can send me instrumentation previous interview papers? I prepare for MNC Company Interviews? my mail id- Rakesh.Golla@dodsaldxb.ae , and another mail rakesh.gvk@gmail.com
What is the advantage of using locally fabricated hook ups over Pre fabricated hook ups in process instrumentation?
Why does a pressure gauge installed on reactor, doesn't have any vent line below to release the pressure? Is it any kind of designing mistake or it actually does not require any vent line? And if it does not require any vent line below it then how we are gonna release the pressure built inside the pressure gauge?
