How the STP determinw that which Port should be Root Port,
which port should be Designeted Port , Blocking Port and
Forwarding Port in Layer 2 STP topology
Answer Posted / venkatesh
ports enter into the root bridge,these ports are called as
designated ports.The out going ports which are enter into
the root bridge is known as root ports.The alternative root
for the network is known as blocking port.Which port
overcome the listening,learning,blocking modes is called as
forwarding port
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Which command we use for ping in ipv6?
Is hsrp is cisco proprietary or introduced by ieee?
What is default time of hello packets in ospf?
Which command we give if router ios stucked?
Which way of communication bus topology use?
When we use loop back ip?
Can you explain PPP protocol?
When we use standard access-list?
Define bandwidth?
Which type of transmission bus topology support?
What is default cost of serial interface in ospf?
What is difference between static and dynamic routing?
Which table find best path?
Explain the draw back of eigrp protocol?
Which cable called roll-over?