Why transformer rating in KVA?
and Generator also?
- 6 Answers
- 11229 Views
- Bhel, IEEE, Toyo Denki, Toyo Engineering, I also Faced
- E-Mail Answers
Answer Posted / aniket
as the is not known we cannot know the power factor so cant xpress in watts so in kva
| Is This Answer Correct ? | 5 Yes | 14 No |
Post New Answer View All Answers
What is the comparison between 30mA DP RCCB and 100mA DP RCCB and can replace it against 63A MCB
if 12v battery get discharged for 2 months after if we put charge it will charge again?how much time it will take to charge?
while doing high voltage test on 11kv/433 distribution transformer why we only give 28 kv on hv side and 3kv on lv side for power transformers what is the value what factors it depends
In diesel generator how AVR get voltage to excitation. And basic diagram DG EXCITATION CIRCUIT.
what is working process of star delta controlling circuit ?
I meggared my 2c*70 sq mm AL AR XLPE cable. its one end show 50 M ohm . is my cable is safe for laying. I have only one phase and neutral.
Are Refrigerators & Deep Freezers the Inductive load ? How to calculate the Power Factor & hence the Output Power for them ?
pls,send the previous year written test questions.
Define cut-off rate?
impliment (AB)`+C to transistor representation
How short circuit MVA(Fault MVA) in a power system calculated for calculating number of earth plates ?
How to design harmonic filter at the project stage without nowing the harmonics levels
sir, what is the importance of Fault MVA. how to calculate fault mva of 33kv substation connected by 6.5 km line(single circuit with equal spacing) with 110/11kv transformer in 110kv susbstation.the fault mva on 11 kv bus in 110kv susbstation is 208mva.
11kV capacitor bank of rating 2.4KVAR, is charged with protective relays of only over current & Earth fault &.......without Over Voltage, Under Voltage & Neutral Displacement Relay. Is it advisable??
what is difference between bus coupler and auto transfer switch
