Answer Posted / tanu singh

rating of any machine is depend to the losses in that m/c.
in x-mer, the iron losses and hystersis losses dependent to
the voltage. and copper losses depend to the current. it's
the only reason to take the ratings in kva.

How to derive detailed design of Suitable bus Bar for 100A for 6.6KV?

1820

---

What are the necessary components of the feedback control system?

1232

---

what is circuit breaker in transfomer and where it used

1189

---

how to handle 2500 kva transformar

1636

---

How will polarity test of Dy5 Transformer ?

2271

---

what is formula to cal cute earth pit numbers and size of earth strip used in earthing?

2224

---

I have made a 3 phase thyristor full bridge rectifier. But at the moment it is working only for the half bridge operation. Both the half bridges are on operation separately but when i put it into full bridge operation the oscilloscope output is zero. I rechecked that the pulses are correct for each thyristor. what could be the possible reason for this?

1972

---

HOW TO CALCULATE HV TEST VOLTAGE FOR ELECTRICAL EQPT.

2225

---

How to test Alternator stability test for REF relay

1489

---

If Neutral Grounding Resistor (GR) failed/shorted. Is it repairable.

1640

---

1. What is maximum permissible distance between smoke detectors ? 2. How do we decide number of smoke detectors required in a large office, warehouse, hall etc ? 3. What should be maximum height of smoke detectors ? 4. Where do we use heat detector, optical smoke detector, temperature sensitive detector ?

2921

---

State the formula for overall efficiency of thermal power station

3047

---

How to calculate the no of Ceiling fan (1200mm sweep) per unit area?

2081

---

the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?

2293

---

how to read idmt curva

2294

---