Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / dhiraj shringi
the power upto the fault in power system is known as fault
level power.
it is calculated by the following formula:
fault MVA= BASE MVA/PU IMPEDANCE upto fault level.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
When calculation of fault current and fault Kva is to be done,why always we use per unit value and why we consider the base kva?
Saving in copper achieved by converting a 2 winding transformer in to an auto transformer is determined by A voltage transformation ratio B load on secondary C quality of core material D size of transformer core
Which device of PlC does share load between DG sets when DG are running in perallel?
how can tell us the AC indoor or outdoor which Tr and formulls
i had aplied Hindustan Petroleum corporation limited for the post of maintenance technician -Electrical,i want model questions,if anybody have please send it or please advice?
What are all present producing cost of Per KWH of various Fuel?
How to calculate Temp from Resister from PT100 equation,
Hi Everyone ! My Name is Hakim ullah khan please i need formula of Cable Rating because i want to calculate by self without check any Table Chart... Thank you.....
What is the difference between Droop vs Isoch Control?
How is the gain affected by the introduction of feedback in a control system.
What is a compensator?
how commomn gate triggering is given for TRIAC ? other thyristor wont be efffected?
Please send 110 kv sb station full single line drawing(sld)
how tto ingress mw in turbine explain.procedure ?
i will applied in 1U-1W on 440 volt primary delta side. what is the result of magtic balance test
