Interested to Buy Any Domain ? << Click Here >> for more details...
If the damper winding on the rotor of a synchronous motor is
removed after starting what will happen?
- 7 Answers
- 14061 Views
- IOCL, I also Faced
- E-Mail Answers
Answer Posted / mehmed
damper windings are mainly used to provide startn torque
for sync motors.though under the normal running
condition,the damper still carry little current even the
rotor runs at a synchronous speed, it still can be removed.
i already done the lab experiment.
its another purpose is to prevent hunting(i.e,momentary speed
fluctuation) n helps the motor to run @ sync speed by
preventing oscillations.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
Give me the calculation steps to design an electromagnet to be work in 230V 50 Hz AC Supply. Also give force that is created by that electromagnet when it gets energized.
what will happen if there is a voltage leakage or current leakage in an electrical train
How to measure the earth resistance value in a concrete pavement(flood light area)?
what is basic difference betmeen normal & flame proof motor??
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
What are the Full Forms of TVM, MTL, CVT ?
What are the material used for resistor?
If I have Energy Meter Ratio as 100:5 & Also I have CT Ratio as 50:5 then what will be my multiplying Factor(M.F.)
what is smartµ grid technology?under coal gassification?
what is the best transformer oil breakdown voltage?
How can we find out LT UG cable fault (size,from-4*25mm sqr to 4*300mm sqr)? How mani types UG cable faults?
We have studied about many techniques for finding the stability of system, ROOT LOCUS, ROUTH, BODE PLOT, POLER PLOT etc. In these which is used where. what are the difference among them... PLZ tell me.......
explain transformer ct connection?
Why you want to join non technical field when you are an engineer?
how we decide wire gauge for ac or dc coil and what is the basic diff. B/w these two coil?
