Why DP transmitters are subjected to high static pressure
test of 100 bar. Though they will be used for very small
pressure range
Answer Posted / komal
Static Pressure is done on DP transmitter because of check
if the transmitter can withstand the static pressure acting
due to Line Pressure when in process. The Line pressure can
be 100 bar but the DP that is measured on transmiter can be
as small as 1000 MM H2O.
Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
how to tune siemens sipart electro pneumatic positioner..plz tel me..
What are primary elements of measuring pressure? Which type of pressure can be measured by these elements?
What is force balance principle? State some of its’ advantages.
Manipulation of dead wt. tester double piston type.
How many types of sensor
Any one can help me to identified, how can we interchange the device in FF
Is there any relation between Artificial Intelligence and Instrumentation?
how to convert MA in to measuring values..and how mwasuring values into MA ?..plz ansr.i have intervw
few questions on RS 232,1 question on relationship of impedance and turns ratio, many questions on flowmeters
all types instrumentation questions want
Explain the working of rota meter.
why orfice is not used for main steam flow calculation
What is three element drum level control system why its better than single element?
for oil & gas industries which zone is normally preferred? why? give its example?
In power plant to measure vibration of a turbine we install sensors. Before install this sensor we have to set gap voltage. What is meant by gap voltage and its use?