Answer Posted / nikunj
DG lube oil Specification is 15W/40
Difference between DG oil and Transformer oil is
DG oil is used for lubricating purpose because in DG Engine
lot of rotating parts are there,
Transormer oil Specification is 40KV and it is mineral oil
we are using oil in transformer for insulating and cooling
purpose
Is This Answer Correct ? | 2 Yes | 4 No |
Post New Answer View All Answers
What happened if C.T mount at any cable or Bus bar in wrong direction . C.T going on proper work or not . C,T direction is essential thing to properly work.
can we synchronize star system generators with delta system transmission line ? and how ?
how can we calculate the ampacity of the electrical wire/cable. and what are the factors must be considered. pls. elaborate.
what is the safe meggar values for motor, transformer HT, LT and Cables? IF we want to replace I/C bay at our 220 kv substation which is of 140 mw load capacity bay to be replaced by 400 mw capacity bay.other than CT(1200/1) what are the other equipment i have to replace. why we generally use 3.5 core cable or in other word 1/2 core for neutral and also confirm me that in balance conditiob(3 phase)current in neutral will zero
what is automatic voltage regulator?we can control the vlotage by using fuzzy controller in matlab?why we go for fuzzy?
What is the direction of current flow in ct secondary...means if the current is flowing from P1 to P2 then what will be the direction of current flow in ct secondaryw
what is transient enclosure vltage , very fast transients, very fast transient over voltages
PLZ SEND ME SOME UNIQUE PROJECT OF ELECTRICAL ENG (B.TECH)
What will happen if i used 11KV earth ht kit to 11 KV / 11 KV cable termination?
what is the saturation point of crgo lamination.
What is the use of Surge Capacitor in LAVT?
How shall i select the value of capacitor or inductor in a system?
condition Autotrip facia come on control panel of electrical transmission line?
If 22 KV HT line, Current transformer is 25/5 then how to calculate multiplying factor.
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?