Interested to Buy Any Domain ? << Click Here >> for more details...
how can be connected thermocouple in series?what is the
need?
- 2 Answers
- 9445 Views
- Hindalco, I also Faced
- E-Mail Answers
Answer Posted / s.sasikumar
thermocouple can connected in series with polarities
reversed to measure difference between two temperatures.
steps:
1.take 2 themocouples
2.connect in series and give it to mesuring device.
3.display shows the temperature difference between two
thermocouples.
| Is This Answer Correct ? | 12 Yes | 2 No |
Post New Answer View All Answers
What is the diffrence between ff tx and non ff tx
what is compensation? temprature & pressure
what is output of FOUNDATION FIELD BUS transmitter
How do bending tubing provide better measurement than using tubing fittings such as elbows?
we want to control pump in let pressure and tank (for exp) our inlet line if water cam and pump will on and when our tank will full pump will off also if our inlet pressure low pump will off even tank not full.this pump i want to uses on our water supply line.
what is installation and commissioning of (fat & sat) of power plant dcs ? this question keeps in desirable conditions of one company .
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
hello sir/madam, I,Subramanian need 5yrs placement papers of officer trainee of Instrumentation technology.pls send to this mail id mani_nxtgen@yahoo.co.in please do the needful. with regards, subramanian.v
why direct mounted pressure transmitters is always installed with DBB ( double bleed block) valve in process line or top of the tanks ?
What is cut off relay? And why use in PLC and DCS?
what are the selections available in configuring a burnout protection of a controller? thanks
can any one tell me when ongc placement test and its forms is available????/ pls tell me if u know
where proximity sensor installed on tank in loading arm application
How to decrease opening & closing time of on/off valve?
the 3 most common transmitter protocol being in refinery or qatar gas and aramco.
