Do you know how to measure the earth resistance? if so
explain it
Answer Posted / segun
yes this is done using resistivity meter(terrameter) with
fou electrode,
Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
what is the voltage rating of chiller unit sensors
WHAT IS IEC? & WHAT IS BENEFIT TO PRODUCT FROM IEC?
we have one oven for 12 zone we are installed ir lamp in oven we control load from thyrister and 0 to 5vdc so our zone no 8 getting bright in fraction of second so what we do.. Please answer
What is the comparison between 30mA DP RCCB and 100mA DP RCCB and can replace it against 63A MCB
i m electrical diploma holder i want to do plc $ Scada some body tell me which insitute is best for me near chandigarh
What should be the voltage between Neutral and Ground in secondary side of the step down transformer (230 V to 110 V) with no load condition?
Under wat condition statcom operates as an inductor for the transmission line?
how can we understand that where we have to use ac or dc coil for solenoid valve and why?what is the different between coil of ac and dc explain please.
what is the difference between directional & non directional earth fault with example please explain.
Please help me regarding my one concern. - During earth pit testing we noticed that the Clean earth pit and dirty earth pit showing continuity (Resistance value - 5ohm) . I want to know that if both earth pit have separate location and there is not internal looping between PIT then why such continuity is showing on it . Because of this issue the field side all earthing point showing short. In PLC panel we are providing two types of earthing cable which is coming from separate earth pit (Clean and Dirty earth pit) because of earth PIT showing short our PLC is not complying spec . please help regarding this issues.
what is meant by impulse voltage?
what is meant by impedance & transient protection?
Can we use Ccapacitive voltage transformer directly for metering purpose?
what are the specifications we must look at to select a relay for any capacity motor?
Greeting to all members, How to calculate spill current when we have different ratio CT and Class for REF(Low Imp) I have 500/1A 5P20 @line side n 400/1A CL.X @ Neutral.