Interested to Buy Any Domain ? << Click Here >> for more details...
what is plc?
- 27 Answers
- 45035 Views
- HPCL, KRL, Noor Company, Petrochemicals, SS Automation, I also Faced
- E-Mail Answers
Answer Posted / manikandan.k
plc is also one of a computer. This is control the different
device in the logic program is done in the computer.
| Is This Answer Correct ? | 4 Yes | 3 No |
Post New Answer View All Answers
What is the difference bitween control net scaner and device net scaner
Why MUX JB's are using only Temperature Element in Fundation field bus?
Define the difference between a stable versus an unstable controlled system and some of the tools you might use to be able to detect when this is happening and assumptions used for control system application design that could contribute to instability
What materials are used in thermo wells?
when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
how to calculate range of level transmitter?
all types instrumentation questions want
In bently nevada vibration monitoring system,what is the reason to maintain the Resistance of the probe + extension cable equal to 95 ohm? If possible explain the basic principle of measurement with detail electronic circuits.
how to calibrate Necleuonic level transmitter.?
What is the use of control cable?
How can a d.p. Transmitter be calibrated?
How to Calibrate Interface Level Troll in field
How to control flow variations in magnetic flow maters..... When i will provide proper earthing?
There are two chlorination tonners both are connected to two pressure swithes and the pressure switch is connected to SOV which operates the valve to changeover the tonner selection i.e if pressure one tonner goes low the other tonner should come in line if it is inautomatic selection design a circuit using relays ?
