Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / saravanakumar
Smart is an electronic circuit based on micro controller that is present in transmitter.
| Is This Answer Correct ? | 5 Yes | 3 No |
Post New Answer View All Answers
what is a good line as ic engineer as maintenance ,oc, project, calibration ,validation engineer?
Calibration procedure for Electro magnetic Flow meter
dear sir we have insatlled positioner model no.sipart PS2 make Siemens at our control valves . now problem is if we want to increase the response of valve opening speedy /fast. what parameters do we change for positioner ? any idea. please guide us.
give me all the details about the interview and which type of question being asked
Why plc require in analog input 4-20amp & 0-10 volt?
What is the meaning of wet leg
Why mmwc unit is used?
Can anybody please let me know Orifice plate sizing calculation formula and step by step procedure
What are different types of orifice plates?
what is the reset offset and control system in instrumentation
Introduce yourself which is not present in your biodata?
key exchanges in wpa,wpa2,tls
Dear Friends, we are planning to design Power distribution and Fiber optic in the same cabinet.Like Front side Fiber optic and Rear side Power distribution.Is it any possibility of problem occurs like interference etc? Your answer is highly appreciate.
Pl send the model question paper of mahagenco account officer post
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
