Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / svv naresh
it is d combination of 3mols of pyridine,1mole of so2,1m
ofi2,1m of meoh
| Is This Answer Correct ? | 8 Yes | 3 No |
Post New Answer View All Answers
how to qualify the impurity?
What is similarity factor and its use in api strength?
How to calculation of residual solvent methanol (3000 ppm) standard solution, and how many quantity used of test sample
My question about gas chromatography sulfur chemiluminsecence detector. I test unknown sample gas by GC-SCD (calibrated ) and the result of *H2S is 279 PPM , *but when I test the same sample with the GC-TCD (calibrated ) the value of *H2S is 2500 PPM . I'd like to inform you that both GCs are calibrated and have very good operation conditions with stable parameters . the question is if the sample gas with higher H2S over detection limits of SCD detector (1000 ppm). why the result it 279 ppm Best regards
How to set specification of assay, fisdolution and related substances?
how to set sample and standard concentration in RS method?
[3/28, 20:52] Manoj P Venkatpurwar: how many impurities require to inject in assay specificity that how we can find out? and in Rs also how?
how to calculate elemental impurities?
why octanol used to determine the partition coefficient ?
Ph meter can show more than 14 ph reading? Why ph range in between 1 to 14 only?
how to selecet an exact coloumn for an new molecule development by hplc how to select exact salt as buffer for new molecule development by hplc what is the the process to select the mode of saparation of compoundes by hplc what is the use of ph of buffer what is use of buffer,ph,organic phase,ans methods how the molecules get saparated in coloumn,
I have compare C2H2-air and C2H2-N2O flame AAS on determination calcium. Both use same range of std to plot calibration curve. (2-6ppm) When i measure the sample with phosphate, KCl and LaCl, C2H2-N2O flame give false positive result, around 0.5ppm. When i measure the sample with phosphste, KCl and EDTA. C2H2-N2O flame also give 0.5ppm false positive. But both above mentioned sample would not give false positive when measured by C2H2-air flame. What is the reason?
What is the principle of Thermal conductivity detector and FID?
What is mean by PDR?
Loss of linearity in tkn analysis, possible reasons?
