Answer Posted / ravikumarts. knightfrank
Earth : its connected to the body of all critcal equipments
like motors, panels, DG transformer to prevent shock &
safety for all machines.
Neutral : its required to complete the flow of current in
closed ciruit.
Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
why on axial hitting up of air blast on hydrogen produced in oil circuit breaker,temperature rises of the core of the arc?
in wind mill use 2100 kw asychronous generator ( induction generator ) rotor voltage : 3300,stator voltage : 690, rpm : 1511 type : MRL063E04 ' we check rotor resistance magger value found following. R-EARTH - 00 M.OHM,Y-EARTH-34 M.OHM,B-EARTH- 33M.OHM R-Y: 31 M.OHM, Y-B: 00 M.OHM,B-R :33 M.OHM HOW CAN I TAKE DECISION?pls ans. quickly
Leakage current,un balance current which relay using for high voltage transmission?
What is the ideal position cooling fan inside the dc motor?
How to set a Zone 1 distance relay for distribution feeder?
why we use ac supply as 415 volts instead of 415 v why we cant apply 230 v for dc
difference between ac series and parallel circuit
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
Why does the rotor rotate?
what happen if drive input fail momentry at 48.5 HZ frequency?
What is the difference between electrical earthing and electrical grounding?
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?
how generator avr give to the input?
what is meant by IGBT how they differ from tyristor ?
What happens if we run alternator on under frequency?