Interested to Buy Any Domain ? << Click Here >> for more details...
what are the differenc between vcb and sf6 breakers
- 7 Answers
- 28804 Views
- Google, I also Faced
- E-Mail Answers
Answer Posted / masoom raza
Simple vcb uses vacuum as arc extinguish medium where as sf6 cb uses sf6 gas as arc extinguish medium.
| Is This Answer Correct ? | 14 Yes | 4 No |
Post New Answer View All Answers
please send me latest & previous years question papers for IOCL Technical level questions
What do you mean by power transformer?
What is meant by vector group
wHAT IS CAPACITANCE LATCHING? hOW TO CALCULATE CAPACITANCE LATCHING? hOW TO SOLVE THE PROBLEM IF CAPACITANCE LATCHING APPLIED?
When can we take Neutral as common neutral link?
how to calculate sizing of NGTR (Transformer rating,Loading resistor value and Current rating of resistor) and what is the X/R ratio. Details : 11kV,Capacitance 1.73532 micro farads,40kA for 1sec.
how does the rotating m.m.f is produced in the 3-phase induction motor and how the poles are created in 3-phase induction motor ?
how does it help for selection of a transformer.
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
What are high pass filter and low pass filter? and What are the flowmeter ?
block diagram of 2 ups system connected in hot stand by mode?
Why do we require transformer with less specific weight if supply frequency is increased?
what is the meaning of 5% droop or 7% droop in AVR?
What must be the minimum distance maintained between 2 Generators as per International standards?
why dc is used in control circuit for mv & hv switchgear instead of ac
