Interested to Buy Any Domain ? << Click Here >> for more details...
IN DISSOLUTION TEST S1AND S2 AND S3 CONDITIONS ALL ARE
FAILED THEN WHAT IS THE DESSICION U CAN TAKE
- 12 Answers
- 28098 Views
- Cipla, I also Faced
- E-Mail Answers
Answer Posted / rc
Gupta, WHEN PRODUCT IS NOT MEETING THE SPECIFICATION UPON
TESTING OF 24 UNITS ,IS IT REALLY REQUIRED TO CARRY OUT
ANALYSIS BY SECOND OFFICER?
| Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
What is the purpose of octyl silane columns?
WHY pKa value is more important than pH value of the mobile phase in HPLC?
what is %labelled amount in content uniformity of dosage unit and its calculation?
what is definition of validation? which components are followed give detail?
how you fix the limits of impurities?
My question about gas chromatography sulfur chemiluminsecence detector. I test unknown sample gas by GC-SCD (calibrated ) and the result of *H2S is 279 PPM , *but when I test the same sample with the GC-TCD (calibrated ) the value of *H2S is 2500 PPM . I'd like to inform you that both GCs are calibrated and have very good operation conditions with stable parameters . the question is if the sample gas with higher H2S over detection limits of SCD detector (1000 ppm). why the result it 279 ppm Best regards
if you get peak in blank then what require to do?
How to establish relative response factor for hplc. Why it is required?
we can use expired sample for validation and analyst qualification?
if tech transfer fails whay require to do?
In the isomers,enantiomers give the only physical properties present such that no chemical properties present.
In HPLC calibration, caffeine is used as primary standard for wave length calibration due to caffeine is having dual maxima at 273 & 205 nm and one minima at 245 nm. Any body can give reference of these details from any pharmacopeia (with chapter no.) or any other authentic guideline?
identification is for unknown? qualification for known? reporting for LOQ?
WHAT IS THE USE OF STARTER ?????????
UV and PDA detector, which have less signal to noise ratio?
