why nearly all the voltage levels are in the multiples of 11
like 3.3 ,6.6 ,33 ,11 kv.....
Answer Posted / nisarg d. patel
In India we provide an offset of 10% overload on the rated voltage level to easily accomodate the varying overload.So in accordance with this, 10 KV becomes 11, 60 KV as 66 and so on and so forth.But this convention is not followed in EHV above 500 KV where we follow the international transmission voltage levels like 730 KV, 1200 KV and so on.And also because the form factor is 1.11 so it becomes symmetric to have the transmission level as 1.1, 3.3 etc.
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
which capacity of RCCB used for five thousand watt electricity load?
How cmd is calculated in case of energy neters
I want to know Electrical Circuit?
Why i receive the GCU fault in my DG Sychronization panel . what all the factors considered for this fault .
hi can any body send me syllabus of rrb electrical section engg... and past pepar also of any board...
What are differences between Voltage, EMF & Potential difference ?
How will A Medium voltage circuit breaker(11 kV voltage level) operate under short circuit fault condition whether It is having short circuit release like Low voltage circuit breaker or relay should be given?
what is meant by twilight switches 7 where its applicable ?
What is relation between transmission lines & Communication lines ?
why EMF IS INDUCED IN A CONDUCTOR WHEN FLUX LINKING WITH IT CHANGES ACCORDING TO FARADAYS LAW.
acb(AIR CIRCUIT BREAKER)NOT CHARGING AUTO
How to synchronization will be done between two DGs ?
What are the advantages and disadvantages of negative feed back?
Give two basic speed control scheme of dc shunt motor?
we are having 110 Kv,250mA Electrostatic precipitators for coal fired boilers. what will be static voltage and current after discharge and what time it will remain before earthing?