Why dc supply is used for closing and tripping coil of ht
breakers. What happen if we use only ups ac supply only.
Answer Posted / er sushil saini
this is because whenever fault occur the ac supply will
also fail so protection system will not work and damage to
equipments can occur. DC supply in battery bank will always
be available in case of ac failure and protection system
will work and trip the breakers.
Is This Answer Correct ? | 44 Yes | 4 No |
Post New Answer View All Answers
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The slip when motor stalls is A 1 B 0 C 13.33% D 10.33%
USE OF 8 WAY PAN ASSEMBLY
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
Plz tell me how we can find that particular company has vacancy or not
How much load can be taken for chiller from 1500 kva transformer
how is positive, negative, zero sequence is happen.. how is effect on 3 phase system
plz send me Bhel, Mahagenco, sbi previous exam paper for electrical engineer on my email-id kambali_smita@yahoo.co.in
How can we calculate cable size in Low voltage & high voltage
What is open loop and control loop systems?
plz send me the procedure and syllabus for mseb exam
please explain to me how to calculate current,voltage,resistance with formula??
Why is better to have a minimum ceiling voltage of 250% than 160%?
what is the internal working of star delta starter
WHAT IS MEANT BY OVER EXCITATION IN GENERATOR TRANSFORMERS? DESCRIBE IT.
if the load is 80 amp for main fuse and 100 amp for breaker so how can we calculate the cable size (cooper ) .