What is the SCAN time of a DCS/PLC? What is the typical
value for scan time of DCS and PLC?
- 6 Answers
- 49255 Views
- Essar, Gasco, Siemens, I also Faced
- E-Mail Answers
Answer Posted / mohamed yousuf
scan time means the time required to read the
inputs,execute the program and generate the output this is
called scan time the scan time is usually in milli seconds
to nano seconds
| Is This Answer Correct ? | 38 Yes | 3 No |
Post New Answer View All Answers
Q-Explain the different load conditions that will produced different offset which may or may not be acceptable to thhe control function
what is the procedure to callibrate temp controller ,pressure controller,etc. suppose a temp controller showing error 1.5 degree centigrate how can i minimize it.
How to calibrate radar type level transmitter for interface level? Total liquid(liq.1 and liq.2), level both the liq individually? For. Both the liquid levels how the signal will go from transmitter to dcs? How to calibrate. Single radar 9:26:55 AM for 2 different liquids in a tank?
how do we commission inergen system?
steps for installing orifice plate?
What is the difference between ff transmitter and non ff transmitter
How is work 5/2 sov?
how to calculate range of level transmitter?
Speedtronic system .
To become an Instrument DESIGN engineer, is there any softwares or training to become Instrument Design engineer, plz suggest me, Iam very much interested in designing.
How vortex sensor used for steam flow measurment can be checked on line i.e without taking out from process line.
What is the PLC configuration in Cement industry?
what does the ratio 800-400-300-200/1-1-1-1-1 in the specification of current transformer indicates?
Question on maha cement
In which principles tx ,pressure gauge,Temp gauge,control valve works?
