what is the purpose of vector group in a transformer ? if 2
tranaformers r connected in parallel the vector group is
same or not?
for parallel operation 2 transformers of different
manufacturers maintain same vector group or not?
- 3 Answers
- 12823 Views
- Orchid, I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
Vector group of CTs is widely used in numerical relays to
compare primary and secondary currents without regard to
the circuit of the transformer
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
we have require a Motor (1500kW, 6.6kV, 50Hz) which shall operate at 1500rpm during 30min and after it shall run on 500rpm during 15min. The same cycle shall be repetitive during the whole working days. Which method is best and economic to achieve such type of task. VFD, VVFD, Pole changing motor etc.
DRAW ACIRCUIT DIAGRAM OF 100 KVA 415V/55-0-55V DELTA TO STAR TRANSFORMER
Define noise?
What are your future plans for the company if permanently employed?
What is the high series capacitance winding on high voltage power transformer ?
what is differnce btwen lll and lllg faults
What is the difference between PLC and Embeded system
What is Instantaneous Earth fault relay,how will work
-What should be minimum value of insulation resistance and maximum value of earth resistance at any electrical instillation and what is method of testing the same.
1) why a dg set shows variation of power factor and load when synchronised with other dgs? 2)Why the load sharing is not become equal in all dgs?. 3)When a dg set will not run on auto start?
How is the speed of a DC shunt motor related to the armature current?
1. What is maximum permissible distance between smoke detectors ? 2. How do we decide number of smoke detectors required in a large office, warehouse, hall etc ? 3. What should be maximum height of smoke detectors ? 4. Where do we use heat detector, optical smoke detector, temperature sensitive detector ?
Proviiding the Dedicated N earth and individual Body Earths ,Finally these all looped /Now my Question :- will it not harm in case of Transformer Fault current flows in Dediacted N Earthing to Looped Body Earthing.
In ht capacitor ckt we are using LBS Panel it having isolator with fuse, one of HT fuse flash over, so what is reason behind this event.
Role of active and reactive Power sharing in between two synchronized Generators, Droop Setting role ?
