Interested to Buy Any Domain ? << Click Here >> for more details...
what is the principale of vortex flow meter.
- 7 Answers
- 13259 Views
- Ambuja, India Glycols, I also Faced
- E-Mail Answers
Answer Posted / mrfa
It has crystal's inside when process pushes they create
milivolts .
| Is This Answer Correct ? | 1 Yes | 3 No |
Post New Answer View All Answers
What is motion balance principle?
Which is the best field foundation bus. ( FF ) Yokogawa, Honeywell or others ?
how does we calibrate a square root flow transmitter ,give an example and explain it step by step like range calculation , calibration hook up series connection , zero check , and how to apply pressure , and if not geting proportional output then what should we do ?
1.what is controller proportional gain 2.what is the controller intergral action time. 3.A proportional plus derivative controller that has a proportional band of 20% and a derivative action time of 0.1 minutes. Construct the shape of the output waveform for the triangular input if the input rises and falls at the rate of 4 units per minute.
how to work MIL contol valve posistioner ?
I want measure the volumetric flow of gas in waste heat recovery Boiler?Tell me how and which type of instruments required. Plz mail me:naba02222@gmail.com Sam please post the answer .
any body please send me the old question papers of ongc test.
Why all the drains(Gland sealing,ESV,Casing inlet etc) are directly connected to the flash tank instead of hotwell of the condensor in the power plant? My Email Id:naba02222@gmail.com
how many type conductivity sensor ?
what is stroke check for field instument transmetter's & AOV's
Specify eight technical requirements that you would consider important, when deciding upon a particular control valve?
explain key exchanges in all security modes WPA,WPA2,TLS?
what is the reason while warning lamp is on while the engine is cranking?
What is the purpose of bypass valve across AS valve.
I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.
