Interested to Buy Any Domain ? << Click Here >> for more details...
WHY AREWE USING THE 3 1/2 CORE CABLES IN POWER TRANSMISSION
- 1 Answers
- 5863 Views
- Phoenix Technologies, I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
If the load is fairly balanced ,the unbalanced current in
the neutral of 3ph 4w system will be very less and hence
the smaller sectional area for the neutral cable to save
money
| Is This Answer Correct ? | 14 Yes | 2 No |
Post New Answer View All Answers
Is there a diode made that works with AC 120 volt 20 amp? If so can it completely stop all current flow in 1 direction at all times?
Which type of DG need Netral Earthing?
what is the best method of grounding in 30 MW generator?
difine electrical ballast in HPSVL
What is the difference between in Fourier series and Fourier Transform. and please tell me the difference between both of them and the why we use them in communication system?
list the advantages of RCCB over other circuit breakers?
how to flameproof electrical motor on the shaft?
Swg formulae
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
what is mean by NPS (Negative phase sequence)fault? what is the difference between EFR & OCR faults?
what is the series parallel connection of capacitors? and how can we use these application in three phase motors for controlling torque?
what material is the electrical housing wire made of? is there any difference for the telephone lines?
What is the effect of pd controller on system performance?
What is the fault or needs to be done when frequency in ac drives is not changing?
why do you add the load short circuit impedance when considering short circuit amperage. It seems that you should only consider supply. If you need to consider loads and you don't know what loads are to be added , what would be a good sub-transient reactance rating for the loads?
