Why in india freq. is 50HZ & in U.S.A. it is 60HZ?
Answer Posted / m.kumaran
Normally the formula for speed is N=120f/P
N=Speed in RPM
f=Frequency
P=No of poles
Example
f=50Hz
P=2
so N=3000 RPM.but we use 4 pole machine we get 1500 RPM
The indian machines are manufactured only 2&4 poles only so
we get 50Hz frequency. but most of indian power generating
stations are follow this technique. but we want to change
this method total methods of generating station will de
changed.
Is This Answer Correct ? | 4 Yes | 5 No |
Post New Answer View All Answers
In an ACB shunt trip coil and undervoltage coil operated normally( breaker open and charged). But closing coil not operating untill manually discharge and recharging. Any help.
What is thresh hold value of current?
write down the formula of cable size in RM if current is 50Amp.
Will any motor burn if voltage provided is lesser than the rated voltage???? If yes, then how is speed control possible with voltage control
What is the effect of pd controller on system performance?
What would cause a 240v choke that should give 110v out on a 16w lamp to gradually increase to 160v?
how to ctrl motor by use of ac or dc drive.plz explain evdintly
sir please send me iocl written test paper in my e-mail account. i'll be obliged to you........ thank u roshan
How much should be the load percentage for 15kva Inverter and Iinut & I output load with Calculations
what is the importance of earthing system on the generators big capacity and small?
What does Bode plot tell you?
Where voltage are high and current to be interrupted is low the breaker preferred is:
what are the advantages disadvantages of connecting high voltage block( 1:1 transformers) transformers between the turbo generators and busbars.
What does the term power factor shows?
How much depth n width required for laying of 1X70 Sqmm Cable in Desert???