Do you know how to measure the earth resistance? if so
explain it
Answer Posted / tofan kumar sahu
Earth resistance should be mesured only by using earth
tester the potential spike must be placed minimum 10mtr
away from mesuring earth pit & auxulary spike must be
placed minimum 10mtr from potential spike.That means the
distance between 2 spikes +the distance between earth pit &
potential spike should not less than 20mtr.
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
how to select proper cable for ct wiring so that drop within the limit.
wat is the current produced in a 5000v megger? when the positive and negetive terminals are touched on our body get s shock?
all interview questions with answers of ntpc (2000-2009
what is method for testing CT
How to convert 2 phase to 3 phase electricpower in induction moter?
Explain the terms real power, apparent power and reactive power for ac circuits and also the units used.
Dear Mr B C pal...Can you plz. put some light on principle of operation of Z-Ct in conjunction to its use with 1Cx1000Sqmm HT Cables & Directional Ground Fault / Over Voltage Relays...Regd..Parag v K 9899115632
i will applied in 1U-1W on 440 volt primary delta side. what is the result of magtic balance test
-What shall be short circuit current of LV switchgear for a 1000 kva, 11.415kv, 3 phase tranformer with 5% reactance.
How can you sized or estimate the ligthning arrester current rating?
In what condition the HT fuse breakes?
oltc of a transformer, how it works? and what are the equipment consist of describe briefly?
what is the difference b/w ATS and HTS?
What is proportional controller?
What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works?