What happens if we give ac supply to dc shunt and series
motors individually
Answer Posted / tanmay goon
motor will continue to rotate in same direction bcoz in ac
supply direction of current in both field and armature
changes simultaneously bcoz of which direction of resultant
field thus torque remains same.
Is This Answer Correct ? | 11 Yes | 2 No |
Post New Answer View All Answers
How should i design a 1ph & 3 ph transformer. Kindly let meknow all steps and formulaes related to design from scratch.
IF 8255 CONTROL WORD IS 94H,Tell the chip port work mode ?
What is different between resistance grounding system and resistance earthing system?
describe the Tranformer testing procedure
why are distributed windings generally used in alternators?
What happens to a motor if it is connected in Delta connection
What is the maximum number of swithes that can be connected in series up to down stream point in an LV Distribution system?
delta motor winding resistance I take normally single winding is 2.5, which value is came delta connection ie RY ?
Explain and give me an example of a time when you had to explain some new procedures to your co-workers for quality service delivery, how did you go about it?
Why can't we take NO LOAD TRIAL of motors having V1 mounting??
54 Comments Alok and Bhanu play the following min-max game. Given the expression N = 38 + X*(Y – Z) where X, Y and Z are variables representing single digits (0 to 9), Alok would like to maximize N while Bhanu would like to minimize it. Towards this end, Alok chooses a single digit number and Bhanu substitutes this for a variable of her choice (X, Y or Z). Alok then chooses the next value and Bhanu, the variable to substitute the value. Finally Alok proposes the value for the remaining variable. Assuming both play to their optimal strategies, the value of N at the end of the game would be?
How to calculate the Harmonics losses in terms of cost/unit.
What is meant by reset level of the relay?
In hydel power plants, L.A's, S.C's are placed inside the control panel boards. what is the purpose? [already the total body was earthed to ground.]
Dear all, how we select the cable size according to current with or without including different correction factor , is there any direct method for sizing of cable...