Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between M.C and LOD
- 21 Answers
- 71994 Views
- Aurobindo, Cipla, Laurus, Matrix, Synthokem Labs, I also Faced
- E-Mail Answers
Answer Posted / manikanta
Moisture content means how much water present in your
sample
LOD Means how much non voltail solvents and water present
in your sample
| Is This Answer Correct ? | 25 Yes | 12 No |
Post New Answer View All Answers
In the HPLC Calibration done wavelength accuracy done between 200nm-280nm .but not done remaining 300-400nm not done ?
how require to fix the linearity and accuracy cincentration range?
AT WHAT CONDITIONS WILL YOU ANALYSE A SAMPLE,WHICH ARE PRESERVED AT OTHER THAN THE AMBIENT CONDITIONS?(ie COLD STORAGE SAMPLES BELOW 20* CENTIGRADE?
what is the difference between potentiometric titration and karl fischer titration?
how require to interprit the method precision data of hptlc?
how you start the solubility study?
Qc interview questions
How to do regeneration of Metacarb Pb plus column?
In BP2013, Loperamid HCl monograph. Assay by titration with 0.1N sodium hydroxide using hydrocloric acid 0.01N and reading the volume added between the 2 points of inflexion. I have a question that if the diluent solvent is ethanol is certainly consumed a amount of volume of titrant, so this volume must be eliminated on the result calculation or not apart from first point which is subtracted above.
My question about gas chromatography sulfur chemiluminsecence detector. I test unknown sample gas by GC-SCD (calibrated ) and the result of *H2S is 279 PPM , *but when I test the same sample with the GC-TCD (calibrated ) the value of *H2S is 2500 PPM . I'd like to inform you that both GCs are calibrated and have very good operation conditions with stable parameters . the question is if the sample gas with higher H2S over detection limits of SCD detector (1000 ppm). why the result it 279 ppm Best regards
which are the sizes of capsules?
in which situation require to use paddle and basket?
What is control room temperature and which guide line says?
how a particular wavelength can be different for a particular compund while analysing by uv and by HPLC.
2. Two grams of Benzoic acid are dissolved in 200 ml of water and extracted with 200 ml of diethyl ether. The distribution coefficient of benzoic acid is 100, and its dissociation constant is 6.5 10-5. Calculate the distribution ratio (D) of benzoic acid at pH 2, 5, and 6. 3. Calculate D at pH 2 to 10 (1 unit apart) in the above problem, and plot D versus pH.
