Interested to Buy Any Domain ? << Click Here >> for more details...
how can we calibrate the differential pressure transmitter
by using HART communicator
- 8 Answers
- 34934 Views
- Hindalco, I also Faced
- E-Mail Answers
Answer Posted / praful lilhare
first of all connect the 250 ohm resistence in series while
connecting the HART to DPT for communication tnen close all
tabs and adjust zero.we can also adjust the range,unit by
using HART communicator.
| Is This Answer Correct ? | 6 Yes | 6 No |
Post New Answer View All Answers
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
why use 50% lel methane gas concentration for gas detector calibration instead of 60% lel gas concentration whereas the hi alarm set at 60% lel.
the whole paper was based on Transducers..questions like define repeatability, error,accuracy,precision..den there were many q. on the conversion of Pa to mmHg and other units.. also..der wer few Q. on some level sensors(with diagram)
what is the difference between scaler and vector drive
I installed the smartplant instrument v8, but can not be opened, that always said: "INTools 2007 hardlock no found". So Could you help me how to do for that?
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
model question paper of instrumentation for Jindal GET 2010.plz reply sudhanshukumar08@yahoo.com
How the sizing of the analog signal cable is calculate?
Draw a wheatstone bridge circuit showing supply, meter and 3 wire RTD connection
Give an example where you had aproblem on the job, and tell me how you solved the problem. and the finalvoutcome.
I have got a call of IOCL interview for projects having 2yrs experience. What sort of questions should I expect in the interview?
ORP sensor working principle?
How servomotor controls throttle valve of TURBINE?
what is the procedure for auto tune in masoneialn 12300 series displacer type transmitter?
Instrument QA/Qc what is the project quality plan?conduit inspection RFI. which documents attache with package?
