how to determine capacitor bank capacity of one plant..
Answer Posted / pichumani
As a thumb rule, 1/3 (30% appx.) of your KVA demand shall
be the KVAR requirement of your plant.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
What are the advantage of free wheeling diode in a full wave rectifier?
Where I can get the sample question for post of Junior engineer electrical-II For RRB Bhubaneswar.
how to meas-our losses for L.T & H.T
If we need 4c× 50mm sq cable but it's not available so we can pull 4c×25mm sq two cables?
which is the most advanced form of SF6 BREAKER?Can we use other gases to quench the arc?
In power transmission using open belts or horizontal shafts it is preferable to have the slack side of the belt on the top because
why are distributed windings generally used in alternators?
why ht cable end termination don't have a gland?
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
what is the prinsiple of dc motor and construction and working ,application of dc motor.
what is smart grid? why we use it? explain in detals bcoz i want give presentatin from it....
what is a bus riser in power system and why it is used
what happened when we supply a dc current in dc motor?? can it worked properly?
What will be advantage if we put some load in neutral of grounded star transformer & loadshortcircuit current,rated current of cable & MCB with example?
in an electronic tri vector meter when the current and voltage sequence changes ? what is the effect of phase sequence on recording of meter