what is the difference between cable routing and scheduling?
Answer Posted / udayak25
s, Victor is 100% correct.
in short -
cable routing is a drawing which shows how cables are to be
laid.
&
cable schedule document shows the cable specifications like-
resistance, cumulative resistance, length, terminations etc.
Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
A parallel flow heat exchanger will perform better than a counter flow heat exchanger. State if the statement is true or false.
Installation resistance for whole installation of 16 kva & 25 KVA DTRA a) Between each conductor b) between conductor to earth c) installation resistance for each apparatus, each conductor to earth d) earth resistance for the system of earthing
What is Antipumping Function & If we have C.T how we find the Ratio ?
how we can do the insulation on secondary of ct explain and so that tan delta will within limit
What is Phase to Phase clearance for 800V System Operating Voltage as per IEC61439
we have earthmat at 110KV substation.we would like to take earth resistance.b some says that by connecting earth megger terminals (C1,P1) at middile point of earthmat (at riser) will cause voltage gradient at other earthmat nods and dont get exat earth resistance.when connecting at end nods will get exat value . is it correct .please explain
What happens if the series current double?
Which cable is use for rtcc control panel
Grid fault level [KA]?
Explain thin film resistors and wire-wound resistors
WHAT IS SITTING AMPS IN OVER-LOAD RELAY FOR 1PH OR 3PH MOTORS?IF ITS NAME PLATE GIVEN MAX AMPS 10AMPS?
state the working principle of incondenscent tube?
In control room of our one plant there is a continuously the incoming power goes to PC is vary,means in stabilizer it continuously indicate from high input to low and low input to high. what is the reason and its solution.
we have a 2.5hp Starite electric motor water pump,the elec motor burned out,we need to replace starting capacitor(old capacitor specs erased),what microfarad rating capacitor do we need? 110-125V
How the circuit breaker is selected for Induction motor of 100 kW, 415 volt, 0.85 power factor, 0.95 efficiency ?