How the cable size for a motor is decided




Answer Posted / praful nandankar

To limit the starting current there are various protection
devices. Manufacturers always design the motor cable taken
into consideration the after effects of starting current.It
depends on the motor rated current and the voltage drop
which is already mentioned in some answers.

Is This Answer Correct ?    2 Yes 1 No






Post New Answer       View All Answers


Please Help Members By Posting Answers For Below Questions

what is the reactive power what is the use of it in system

984


An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The slip when motor stalls is A 1 B 0 C 13.33% D 10.33%

807


my b-tech percentage is 50%. what answer will satisfy the hr ?

981


Difference between HRG and NGR. Are they both the same thing

2311


how to find number of run cable laying[LT side] for transformer & alternator secondary side? [above condition for getting output power transformer to main panel side] give the example.

980






how we select ac fuse rating of an power inverter???

824


what is meaning of bus riser

1182


which type of motor is used in automatic swing gate

908


WHAT IS THE MEANING OG (li = 7 In)

696


how to differentiate a mpcb,mcb with a contactor? Explain their working operation

997


What is the height of DA, DAL, DB, DC & DDE tower?

936


how can we calculate the ratio of caustic soda and water in lrs.

4055


hi guys please tell me the procedure for mesuring the coil resistance of 3ph induction motor?

757


why normally Generator rating are between 11Kv to 22Kv?

2498


can we use CBCT in neutral of solidly grounded transformer? in place of three phases we can pass only one phase which decreases the size of CBCT?

1075