Answer Posted / intel 8085
percentage impedance is voltage drop on full load due to
winding resistance and leakage reactance
Is This Answer Correct ? | 7 Yes | 1 No |
Post New Answer View All Answers
Is there any question in the name of Static Switch in UPS??
Hi everyone. Some Generators uses 3-Pole breakers with extra contactors for Neutral. Some uses 4-Pole. Why so? What is the idea behind this? Thanks in advance for the solution. Kr.
which type of effect of turbine and generator reverse power protection ?
How to arrange a hous hold earthing system to keep minimum earth resistance( below 7ohms).
Explain how you intend to work under pressure to meet up with deadline target?
is this the formula of building wiring to get the main breaker.Watts/volts*.8%+higher motor*(25%)=ampere. yes or no or send the correct formula for building wiring.
Can the output voltage of a rectifier be greater than the input AC voltage without the use of any voltage multiplier in the circuit??please provide the explanation too..
take 100kva DTR( delta/wye ), what ll happen if we connect 11kv to LT side instead of connecting to HT side? will the DTR behave as a step up transformer or something else????
Following test should be conducted to find out relative polarity of transformenr terminals A no load test B back to back test C phasing out test D none of above
What is an order of a system.
Difference between low impedance and high impedance Restricted Earth Fault
hi friends i m from electrical branch and seeking for tech. + apti. both papers of hpcl plz get it available as soon as possible
what will happen if frequency is below 50 hz?
1.what is the difference between transformer differential and busbar differential.2)why we are using 2 slope for trafo diif and 1 slope for busbar diff.3)what is the purpose of metrosil and stabilizing resistor in high impedance relay circuit.4)how metrosil reduce the peak volage.5)what is the funtion of stabilizing resistor
What happened when capacitor connect series in ac circuit?